News

10 Self Tapping Screw Head Types Introduction

Self-tapping screw head types

A self-tapping screw has the ability to tap threads as it is driven into the material. It is often used only to describe a specific type of thread-cutting screw intended to produce threads in various types of materials, with sheet metal and wood being the most common.

BDN Fasteners offers a range of self-tapping screws. The screws come with either a self-drilling tip for metal or pointed tip for timber. After the tip creates a pilot hole, the thread then taps the metal or wood the screw is affixed to.

On head types. Screws are available in many different head types. Some head types are very application specific, and others for more varied and general applications. Head types are usually manufactured according to set standards according to the region used, though some might tweak or even tailer the design here and there in order to meet special requirements.

BDN Fasteners are manufactured according to the tried-and-true Australian AS standards, offering a good balance between cost and performance, and backed with an industry leading warranty.

HEAD STYLE	DESCRIPTION
	BUGLE HEAD In the smaller gauges up to 8–gauge, this head style is generally used for plasterboard as it does not damage the face of the sheet. The 14-gauge screws with this head style are often used for landscaping and fixing heavy duty decking boards
	BUTTON HEAD Screws with this head type are used for stitching thin steel together and the large head provides a good clamping force on the materials being fixed.
	COUNTERSUNK (CSK) HEAD WITH RIBS (NIBS) This head style is used in a broad range of timber applications where a flush finish is required for the fixing, and the ribs countersink the screw into the timber. It also comes in a variety of drive types depending on the application.
	COUNTERSUNK (CSK) HEAD WITHOUT RIBS (NIBS) This head style is generally used with screws that are fixing steel, where a countersunk recess has been pre-drilled.
	FLAT HEAD / FLUSH HEAD This head style is a low-profile type typically used where cladding is to be fixed over the top, including where plasterboard is fixed to a steel house frame. It is imperative that the head sits absolutely flat
	HEX FLANGE HEAD This head style is used for a broad range of applications including roofing, cladding and timber fabrication, and comes in a range of gauges for heavier duty applications.
	PAN HEAD This head style is used with general purpose fasteners for fixing thin steel to steel or timber substrate.
	SELF EMBEDDING HEAD This head style is mainly used for fixing 3-6mm thick cladding such as Cement Sheet or Blue Board, and the ribs under the head countersink the screw into the material for a flush finish.
	TRIM HEAD This head style is normally used for decking or picket applications where a smaller head is required to avoid splitting the timber when it is installed.
	WAFER HEAD This head style is mainly used for fixing a variety of generally lighter materials to a steel or timber substrate.